GoodNewsoftheDay

True, recent, well-sourced good news, every morning.

ScienceLab study1 min read

Researchers modify cheap printer to build complex living materials

University of Rochester scientists modified a standard plastic 3D printer to create living structures with over one hundred layers.

Previous bioprinting devices cost upwards of one hundred thousand dollars and could not produce tall shapes without collapsing. A team led by Anne S. Meyer replaced expensive parts with inexpensive components found at local stores.

The new setup uses a syringe pump to squeeze bio-ink containing living cells mixed with a specific polymer solution. A special support gel called slurry holds the material up while it hardens into a stable gel form quickly.

Meyer stated that her design allows for crisp shapes with well-defined edges and prevents oozing at the printed structure edges. This low-cost approach enables other laboratories to construct their own versions using easily available parts and online instructions.

The upgraded device creates significantly taller living materials than earlier DIY models which were limited to printing under twenty layers. Researchers also developed a slurry that keeps microbes alive for four or more weeks instead of dying after nine days.

“This new setup allows for printing of crisp shapes with well-defined edges.”

Anne Meyer

More science news

ScienceLab study1 min read

Drones capture Whale breath for genome study

Researchers used drones to collect whale breath samples and complete a full genome sequence without disturbing the ocean giants.

· via Good News Network

ScienceLab study1 min read

Algae diet replaces wild fish in trout farming study

Researchers at the University of California Santa Cruz found that rainbow trout thrive on a diet of only microalgae instead of wild-caught fish.

· via Anthropocene Magazine